Toro Greensmaster 3120 Service Manual page 268

Assembling the Roller (continued)
DPA Cutting Units: Service and Repairs
g206892
1. Seal
Failure to grease bearing lock nut before seal installation may result
in seal damage.
5. Fill the seal 75 to 90% full with #2 grease and apply a coating of grease to
the underside of the bearing lock nut to prevent damaging the seal damage
during installation. Carefully fit a seal onto each bearing lock nut.
g206893
1. Seal
6. Install a bearing lock nut with seal onto each end of the roller shaft. Tighten
the bearing lock nuts until they bottom against the bearings. Remove and
clean any grease from the bearing lock nuts.
Figure 125
2. Bearing lock nut
IMPORTANT
Figure 126
2. Bearing lock nut
Page 7–32 Greensmaster 3120
17230SL Rev C