Toro Greensmaster 3120 Service Manual page 291

Installing the Support Plate
Greensmaster 3120
17230SL Rev C
Refer toFigure 137 for this procedure.
1. Fit the support plate over the motor adapter.
2. Apply a light coating of grease to the support plate end of the groomer reel
shaft and to the seal lip in the support plate.
3. Apply a light coating of grease to the O-ring on the motor adapter and the
pilot bore of the cutting unit side plate.
4. Carefully fit the support plate and motor adapter onto the groomer shaft and
into the pilot bore of the cutting unit side plate. Secure the motor adapter to
the cutting unit side plate with two socket head screws and lock nuts. Make
sure the groomer reel and the support plate rotate freely after installation.
5. Insert the front roller into the LH groomer arm.
6. Install the RH groomer arm:
A. Apply anti-seize lubricant to the shoulder of the groomer arm lift rod.
B. Position the groomer arm over the front roller, through the support plate
bushing and against the cutting unit side plate. Make sure the cutting unit
side plate fits between the height adjustment bolt head and shoulder.
C. Secure the groomer arm to the cutting unit side plate with the plow bolt,
special washer and lock nut.
g229554
1. Pinch bolt
2. Groomer reel
D. Secure the groomer arm to the drive plate with the spring washer and
lock nut.
7. Center the front roller in the cutting unit and tighten both pinch bolts.
8. If equipped, install rear roller brush to cutting unit; refer to
Roller Brush (with or without a universal groomer) (page
9. Check and adjust cutting unit height-of-cut and groomer height settings;
refer to the Cutting Unit Operators Manual and the Groomer Installation
Instructions.
10. Lubricate the groomer bearings; refer to the Groomer Installation Instructions.
Note: After greasing the groomer bearings, operate the groomer for 30
seconds, stop the machine and wipe any excess grease from the groomer
shaft and seals.
Figure 143
3. Lock nut
4. Spring washer
Page 8–13 Belt Driven Groomer (Optional): Service and Repairs
5. Groomer arm – RH
Servicing the Rear
7–39).