Toro Greensmaster 3120 Service Manual page 293

Installing the Drive Plate (continued)
Greensmaster 3120
17230SL Rev C
g229452
1. Pinch bolt
2. Groomer reel
D. Secure the groomer arm to the drive plate with the spring washer and
lock nut.
12. Center the front roller in the cutting unit and tighten both pinch bolts.
13. Install the groomer drive belt and drive cover.
14. If equipped, install rear roller brush to cutting unit; refer to
Roller Brush (with or without a universal groomer) (page
15. Check and adjust cutting unit height-of-cut and groomer height settings;
refer to the Cutting Unit Operators Manual and the Groomer Installation
Instructions.
16. Lubricate the groomer bearings; refer to the Groomer Installation Instructions.
Note: After greasing the groomer bearings, operate the groomer for 30
seconds, stop the machine and wipe any excess grease from the groomer
shaft and seals.
Figure 145
3. Lock nut
4. Spring washer
Page 8–15 Belt Driven Groomer (Optional): Service and Repairs
5. Groomer arm – LH
Servicing the Rear
7–39).