Table of Contents
Advertisement
Installing the Traction Pump (continued)
Greensmaster 3120
17230SL Rev C
5. Make sure two (2) spacers (item
rubber coupler and secure the pump hub to the rubber coupler with two (2)
hex nuts, flat washers, and lock nuts.
6. Connect the traction control cable:
A. Secure the traction cable ball joint to the cable bracket.
B. Secure the control cable to the cable support with the jam nuts on the
cable. Make sure that a washer is positioned on each side of the cable
support.
7. Remove the plugs and the caps from hydraulic hoses and fittings and using
labels placed during traction pump removal, connect the hydraulic hoses
to the traction pump fittings. Tighten the connections as specified; refer to
Installing Hydraulic Hoses and Tubes (O-Ring Face Seal) (page
8. Install the gear pump; refer to
26
in
Figure
Installing the Gear Pump (page
Page 4–89
56) are fit into the holes of the
4–8).
4–82).
Hydraulic System: Service and Repairs
Advertisement
Chapters
Table of Contents
Troubleshooting
