Toro Greensmaster 3120 Service Manual page 185

Installing the Hydraulic Tank (continued)
Greensmaster 3120
17230SL Rev C
1. Lubricate and fit new O-rings onto the tank fittings. Install the fittings making
sure that the fitting location and orientation is as noted during removal.
Tighten fittings as specified; refer to
2. Fit the hydraulic tank onto the machine frame.
After the hydraulic tank is installed, a 3.2 to 9.5 mm (0.125" to 0.375")
clearance should exist between the hydraulic tank and the fuel tank.
3. Apply anti-seize lubricant to the threads of the three (3) cap screws and
secure the hydraulic tank to the machine frame with the cap screws, the flat
washers and the bushings. Tighten the cap screws from 3.4 to 6.7 N∙m
(30 to 60 in-lb).
4. Install the carbon canister assembly to the hydraulic tank with the two (2)
cap screws and the spacers. Tighten the cap screws from 12 to 16 N∙m
(110 to 140 in-lb).
5. Remove the plugs and the caps from the hydraulic hoses and fittings. Using
the labels placed during removal, connect the hydraulic hoses to the tank
fittings. Tighten the connections as specified; refer to
Hoses and Tubes (O-Ring Face Seal) (page
6. Charge the hydraulic system; refer to
4–79).
Figure
IMPORTANT
Charging the Hydraulic System (page
Page 4–139
82.
Installing Hydraulic
4–8).
Hydraulic System: Service and Repairs