The Groomer Arm Assemblies - Toro Greensmaster 3120 Service Manual

The Groomer Arm Assemblies

g229587
1. Groomer arm – LH
2. Flange nut
3. Grooved pin
4. E-ring
5. Lift rod
6. Lock screw
7. Bushing (2 each)
Removing the Groomer Arms
Installing the Groomer Arms
Belt Driven Groomer (Optional): Service and Repairs
8. Lift arm assembly
9. Detent spring
10. Lock washer
11. Cap screw
12. Bushing
13. Wave washer
14. Adjuster
The right side and left side groomer arms and lift arm assemblies are unique, the
remaining components are the same on both side of the groomer.
1. Loosen pinch bolts that secure the front roller shaft to the groomer arms.
2. Remove the lock nut and spring washer that secure the either groomer arm
to the plate assembly.
3. Remove the lock nut, special washer and plow bolt that secure the groomer
arm to the cutting unit side plate.
4. Remove the groomer arm and the front roller from the cutting unit.
5. Repeat the procedure for the remaining groomer arm.
6. Disassemble the groomer arm as necessary. Clean and inspect all
components and replace items as necessary.
1. Paying attention to the orientation of the components for either the left side or
the right side application, assemble the groomer arm as necessary.
A. Install the lock screw before installing the grooved pin. The grooved
pin is used to retain the lock screw.
B. Apply anti-seize lubricant to the threads of the lift rods before installing
the adjusters.
Figure 147
15.
16.
17.
18.
19.
Page 8–18
Drive plate
Lock nut
Spring washer
Bushing
Plastic plug
Greensmaster 3120
17230SL Rev C