The Idler Assembly - Toro Greensmaster 3120 Service Manual

The Idler Assembly

Removing the Idler Assembly
Greensmaster 3120
17230SL Rev C
g228189
1. Socket-head screw (2 each)
2.
3. Motor adapter
4. Bushing
5. Idler arm
6. O-ring
7. Lock nut (2 each)
8. Shield
The groomer idler assembly is located on the opposite side of the groomer gear
box.
1. Park the machine on a clean and level surface, lower the cutting units
completely to the ground, set the parking brake, and remove the key from the
key switch.
2. Remove the reel motor from the cutting unit; refer to
Motors (page 4–110).
3. Remove the groomer reel assembly; refer to
(page 9–13).
4. Remove the cotter pin and clevis pin from the height adjustment rod at the
front of the idler arm. Discard the cotter pin.
5. Remove the two socket-head screws that secure the motor adapter to the
cutting unit, and remove the adapter and idler assembly. Retrieve and
discard the O-ring and lock nuts.
6. Inspect the shields, bearing, and bushing in the idler assembly. Replace any
components that are worn or damaged.
Figure 152
9. Stub shaft
10. Flocked seal (2 each)
11. Bearing
12. Retaining ring
13. Flange nut
14. Clevis pin
15. Cotter pin
16. Collar
Page 9–11 Universal Groomer (Optional): Service and Repairs
Removing the Reel
Removing the Groomer Reel