Section 6
ADDITIONAL INSTALLATION NOTES
All Flow Tubes are supplied with integral line connections. The end-user must supply any adapt-
ers, etc. required for line connection.
When connecting a screwed fitting to a Kynar, Teflon (PFA) or CPVC Flow Tube, please start the
thread carefully to avoid cross threading. Hand-tighten only. If necessary, use Teflon tape manufac-
tured for plastic piping to effect a leak-proof seal (see Appendix A- Engineering Drawings for de-
tails).
Whenever possible, use the mounting brackets to support the weight of the flow tube.
Consult the supplied engineering drawing for important dimensional data.
1011FT Series 316 Stainless Steel Flow Tube
INLET
(Use Swagelok®
Tube Fitting)
Mounting
Bracket
992DFT Series CPVC or Kynar PDFA Flow Tube
Inlet
Mounting
(FPT)
Bracket
Calibration factor (valid
for indicated flow
direction only)
Flow Direction
Indicator
Flow
Direction
Indicator
Model
Identification
6-11
1010PFM-3G
OUTLET
(Use Swagelok®
Tube Fitting)
Outlet
(FPT)