Siemens SITRANS F Operating Instructions Manual page 227

Section 6
You can complete the Installation procedure without actually mounting the flow tube at its intended location. Fill
the flow tube completely with liquid and connect the Up and DN cables according to the Installation/Outline
Drawing. Complete the instructions in this section. If you choose to mount the Flow Tube first, please conform
to the guidelines presented in this section and the Installation Drawing. In any case, do not proceed with these
instructions until the flow tube is filled completely with liquid.
After filling the flow tube with liquid, press
then move the cursor to [Install] by pressing
To invoke install routine press
terrogates the flow tube and analyzes setup data to optimize operation). During procedure,
the meter shows its progress by highlighting the prompt line.
Upon completion, the computer reports the measured sonic velocity. You can accept this read-
ing or press
Note that the default Empty Flow Tube Set is [MTYmatic]. The flow computer deter-
mines the empty flow tube setting automatically during the Initial Makeup, so use of
this menu cell is optional.
Siemens 2 Channel
Key Install to start operation
Select FlowTube
Install Completed?
Empty FlowTube Set
Zero Flow Adjust
Install FlowTube
ENT
. This triggers Initial Makeup (an internal process that in-
Siemens 2 Channel
Drive 27 m 10 [6:
Select FlowTube
Install Completed?
Empty FlowTube Set
Zero Flow Adjust
Install FlowTube
to adjust it (see field manual for instructions).
to access the [Install Completed?] option list and
[1] FLOW1
1S
>Yes
New Makeup
Chan Not Setup
[1] FLOW1
:0]
1S
Install
Chan Not Setup
Chan Not Setup
6-7
1010PFM-3G