Section 8
To connect the 1011TS to a 1010P flow computer
8.4
SELECTING THE THICKNESS GAUGE
Turn on the Meter and press the
Next, press the
key. Observe the cursor pointing to [Dual Channel Flow].
Use
to move the cursor to [Thickness Gauge].
ENT
Press
to enable the Thickness Gauge. This selects the Thickness Gauge main menu. Here you
can proceed to measure the wall thickness or calibrate your thickness gauge transducer.
1011TS Transducer
Holder
Connect XMIT to UP
on 1015AT Adapter
Connect RCV to DN on
1015AT Adapter
1011TS Transducer
MENU
key.
Meter Type
Meter Facilites
Meter Type
Meter Facilites
Measure Thickness
Calibration
Connect to XDCR CH1
terminal on 1010WP
1015AT Xdcr
cable adapter
>Dual Channel Flow
Dual Path Flow
Ch 1+2 Flow
Ch 1-2 Flow
Thickness Gauge
Dual Channel Flow
Dual Path Flow
Ch 1+2 Flow
Ch 1-2 Flow
>Thickness Gauge
8-3
1010PFM-3G