Siemens SITRANS F Operating Instructions Manual page 78

Section 1
1010PFM-3G
Upon completion, the meter reports the measured liquid sonic velocity. Press the key. The meter
will then automatically perform an AutoZero operation, where the meter measures any zero flow offset,
which is used to correct the flow reading. This operation occurs only when the transducers are mounted
in the reflect configuration and is independent of whether or not the liquid is flowing.
After the AutoZero operation is complete, the meter may ask you to register the transducer used in this
installation. It is advisable that you register your transducers, since the registration list is used to
condition the transducer recommendation.
Press and select [YES], or [NO] if you do not want to register this transducer.
ENT
Press to register transducer.
Siemens
MENU
The meter is now ready to report flow. Press the key. The meter will then ask you to save the Site.
Saving the Site is optional and will therefore be covered in paragraph 1.9.
To abort this item, press . This brings up a Flow Display Screen.
Siemens 2 Channel [1] Channel 1
89.68
BAT 100% FLOW GAL/MIN
0.20
Vfo
TOTAL KGAL Vs
0.12
G/M
1474
0.00
Once your site has successfully installed, you can press to scroll between the available dis-
play screens.
Now that you are familiar with the 1010P setup, take the time to read the information about the Installa-
tion Menu in Section 2. Becoming acquainted with the various flowmeter setups in the Main Menu will
help further your understanding of the 1010P.
1-34