I/O Data Control Menu Structure; Analog Out Setup; System 1010 Analog Outputs; Analog Out Setup Data Categories - Siemens SITRANS F Operating Instructions Manual

Section 2
(Note: For Dual Path flowmeters: "1" = Path 1, "2" = Path 2 and "S" represents the system or average channel. These
characters appear to the left of the option list parameter.)
I/O Data Control

2.10.1 ANALOG OUT SETUP

System 1010 provides current, voltage and pulse-rate analog outputs. Analog Out Setup allows you to
assign data functions for these signals. The flow computer's terminal strip contains the analog output
terminals.
Io (Isolated current)
Vo (DC voltage)
Pgen (TTL logic)
Vfo
Vfab
Vs
Valc
Vaer
T1
THE I/O DATA CONTROL MENU STRUCTURE
Analog Output Setup
Relay Setup
Analog Input Setup

System 1010 Analog Outputs

4 to 20 mA varies in proportion to an assigned data function.
0 to 10 Vdc varies in proportion to an assigned data function.
0 to 5000 Hz varies in proportion to an assigned data function.

Analog Out Setup Data Categories

Spanned volumetric/mass flow rate
Spanned unsigned flow magnitude
Spanned liquid sonic velocity
Receive signal amplitude
Relative degree of liquid aeration/cavitation
Current liquid temperature
Io1
Vo1
Pgen1
Relay 1
Relay 2
Iin1 Input
4 mA
20 mA
Vin1 Input
0 Volts
10 Volts
2-53
1010PFM-3G
Vfo
Vfab
Vs
Valc
Vaer
T1
*See Io1 option list
*See Io1 option list
Off
Power On
Hi Temperature
Low Temperature
High Flow
Low Flow
Flow Alarm
Fault Alarm
Soft Fault
Spacing
Empty
Aeration
Interface
Reverse Flow
Batch Tot
Pos Total
Neg Total
*See Relay 1 list
Off
Aux
*numeric entry
*numeric entry
Off
Aux
*numeric entry
*numeric entry