Reflect Mode - Mounting Frames And Spacer Bar - Siemens SITRANS F Operating Instructions Manual

Section 3

3.1.7 REFLECT MODE - MOUNTING FRAMES AND SPACER BAR

The combination of a spacer bar with mounting frames is the easiest way to mount in Reflect Mode.
The result is a rigid structure that eliminates spacing measurements, and maintains the transducer-to-
transducer geometry. In addition, reflect mounting allows you to move the entire assembly while main-
taining the original transducer spacing.
positioned around
Mounting Strap
positioned around
Mounting Frame
Optional on larger pipes,
you can link straps together
Optional on larger pipes,
you can link straps together
to surround pipe.
INSTALLATION - REFLECT MOUNT WITH FRAMES AND SPACER BAR
Transducer Clamping
Transducer Clamping
Spring Clip
Spring Clip
(Not present on
(Not present on some
some
models)
models)
Perform all required menu steps until the flow computer issues the number index and prompts you
1.
to press to finish the transducer install routine. Stop at this point.
ENT
Note the number index value displayed in the Pick/Instal
space the transducers. Check to ensure that you have a matched set of transducers. They both
should have the same S/N number but marked with either an "A" or "B" (e.g., 100A and 100B).
Mounting Strap
Mounting Frame
to surround pipe
NOTE: Minimum Ltn 0.75 in. (18 mm)
Spacer Bar Spacer Bar
Screw Screw
Spacer Bar Spacer Bar
Platform and Platform and
clamping screw
clamping screw
You will use this number to properly
l menu.
3-9
1010PFM-3G
Space Bar Platform &
Spacer Bar Platform &
Clamping Screw Clamping Screw
Space Bar
Spacer Bar
(Front View)
(Front view)
Mounting Strap
Mounting Strap
Adjusting screw Adjusting Screw
1012 Series 1012 Series
Mounting Frame Mounting Frame
Mounting Strap Mounting Strap
Note operational
Note optional 2nd
2nd Mounting Strap
Mounting Strap
shown. shown.
Larger pipes may Larger pipes may
need an additional
need an additional
strap for a more
strap for a more
secure mount
secure mount.