System Info; The 1010P Graphic Display Screens - Siemens SITRANS F Operating Instructions Manual

Section 4
4.9

SYSTEM INFO

This menu provides general information about the flowmeter.
Version
Battery Capacity %
Reset Date/Time
Op System P/N
Checksum
Code
System Time
4.10

THE 1010P GRAPHIC DISPLAY SCREENS

The 1010 Graphic Display is a versatile resource which provides visual access to all system variables
and conditions. Dependent on your selection, details of the display my vary, but all elements are always
clearly labeled with units and variable names. You're always able to move through the various displays
by keying the up or down arrow keys. The meter will hold the last display selected indefinitely or until
pressing the <MENU> key. When you again leave menu, the last selected display will greet your return.
After completing the Site Setup, you should check your local display screen to make sure that every-
thing is operating properly. The meter begins to measure flow as soon as you complete the transducer
installation. When you press the <MENU> key to leave the menu, you will see the hybrid digital display
screen (see page 4-17).
Note that the display screen includes a digital flow, total numeric display and a Stripchart.
The StripChart Contains a number of special elements that deserve mention:
The spanning of the stripchart's vertical axis obeys the same user settings that define the
span limits for the analog outputs. If the variable "pegs", the numerical expression of that
variable will also peg.
Alarm limits, or thresholds, are indicated by triangular cursors shown near the stripchart bar.
These are also defined in the Data Span/Set/Cal area of the menu.
Each time the stripchart is altered in a manner that can cause misinterpretation of already
displayed data (re-spanned, new interval, etc.) a vertical bar is drawn on the stripchart. Only
the data to the left of the vertical bar is correctly displayed.
Due to limitations in display area, certain rate or total units may be displayed with fewer
characters than are needed for unambiguous interpretation. Consult the 1010's Flow and
Total Units menu cells for clarification in these cases.
SYSTEM INFO MENU STRUCTURE
This is the meter's operating system version number. The Technical Services
Group may request this number during a consultation.
Defines remaining battery capacity. Battery alarm beeps when approximately 10
percent of the meter's operating time remains.
Shows the date and time of this meter's last <F4> reset.
Meter's operating system part number.
Operating System verifying code. The Technical Services Group may request this
number during a consultation.
Software Compile Date/Time. Operating System identifier. The Technical Services
Group may request this number during a consultation.
Use to set system time and date. Format: xx.xx.xx xx.xx.xx
4-16
1010PFM-3G