Siemens SITRANS F Operating Instructions Manual page 101

Section 2
NOTE: The <ALT> and <MENU> keys must be pressed before the meter scans through all the
drives, or the selection of the detection mode and the Force Transmit function must
be initiated again.
2. A typical menu screen will appear as shown below and indicate the current ALC (e.g., 50).
This ALC number indicates the current receive signal strength and can be used for further
diagnostic purposes.
Siemens 2 Channel
ForceN fx=8
Transducer Model
Transducer Size
Xdcr Mount Mode
Spacing Offset
Number Index
Spacing Method
Ltn Value (in)
Install Completed?
Empty Pipe Set
Zero Flow Adjust
Pick/Install Xdcr
3. To exit Force Transmit, press the <Left Arrow> and a Detection Fault prompt will appear (see
above). Press the <Left Arrow> again and the meter will return to the Pick/Install Xdcr menu
and highlight the [Empty Pipe Set] menu cell.
4. To force a frequency, repeat steps 1 and 2 above, but press <Right Arrow>. The following
typical display line will appear:
Using numeric keys enter the frequency and press <ENT>.
5. If the Force Transmit diagnostic procedure is not used, the normal [Install Completed?] func-
tion occurs as follows:
To complete the Install process after mounting the transducers press <ENT>.
Siemens 2 Channel
Drive 11
Transducer Model
Transducer Size
Xdcr Mount Mode
Spacing Offset
Number Index
Spacing Method
Ltn Value (in)
Install Completed?
Empty Pipe Set
Zero Flow Adjust
Pick/Install Xdcr
[1] SITE1
m=7 ALC=50
1011 Universal
B3
Direct
Minimum
4
Track 1012TP
0.217
Install
Channel Not Setup
Channel Not Setup
Drive
=0
[1] SITE1
1011 Universal
B3
Direct
Minimum
4
Track 1012TP
0.217
Install
Channel Not Setup
Channel Not Setup
Siemens 2 Channel
Transducer Model
Transducer Size
Xdcr Mount Mode
Spacing Offset Detection Fault
Number Index Press [ENT]
Spacing Method
Ltn Value (in)
Install Completed?
Empty Pipe Set
Zero Flow Adjust
Pick/Install Xdcr
2-23
1010PFM-3G
[1] SITE1
1011 Universal
B3
Direct
Minimum
4
Track 1012TP
0.217
Install
Channel Not Setup
Channel Not Setup