The Fug1010Gcn Installation Menu; Manual Conventions; General Installation Menu Notes - Siemens SITRANS FUG1010 IP65 NEMA 4X Instruction Manual

Section 4
4.

THE FUG1010GCN INSTALLATION MENU

CAUTION: The FUG1010GCN flowmeter menu parameters may have been pre-set at the fac-
tory. The following section is provided for user reference should it be needed. High-
lighted paragraph headings within this section indicate those menu cells that
should be used only if the site needs to be completely installed.
For example:
Use care particularly when changing Site Setup and Transducer Install menu cells.
Note also that the FUG1010GCN may be shipped with a factory preset Site Setup and
that it is recallable.
Programming FUG1010GCN requires no special experience or training. This field manual contains all
the necessary information. If you intend to connect this instrument to an external device, then please
have the instruction manual for the device available for reference. The following paragraphs present a
generic menu reference that applies to all configurations of 1010 flowmeters.
This section contains a general description of how to enter site setup data via the FUG1010GCN Instal-
lation Menu. It assumes that you have already selected a meter type as described in the Getting Started
section. For convenience, it presents the Installation Menu in the same sequence as it appears on the
menu screen. Please note, however, that it is not necessary to program the meter sequentially.

Manual Conventions

When the text refers to a keypad key, it will be enclosed in "less than" (<) and "greater than" (>)
z
symbols: e.g., <MENU>, <ENT>, <Up Arrow>, etc. Where a visual of the key is shown; this means
press this key.
When the text refers to a menu or menu cell name, it will be enclosed with square brackets: e.g.,
z
[Gas Parameters], [Channel Enable], etc.
Each menu includes an image of its main screen and a diagram of its structure. The rightmost
z
column of the structure diagram lists the option list choices of the menu cell, if applicable.

General Installation Menu Notes

If a power failure occurs while you are entering or editing data, the entered data may not be retained
z
in Active Memory.
Although you can operate the meter immediately after completion of a site setup, we recommend
z
that you preserve your settings by saving them under a site name. Site data can be saved at any time
before invoking [Recall Site Setup] or [Create/Rename Site] commands. These commands overwrite
all data present in Active Memory.
We do not recommend that you attempt to operate the flowmeter at a new site by recalling and then
z
editing an existing site setup. Each site must have its own set of transducer install parameters, even
if the data from the recalled site setup is identical. Always issue the [Create/Rename Site] to begin a
new site setup. This will fill all the menu cells with defaults to eliminate the possibility of retaining
unwanted parameters.
The meter allows you to create your own personal site setup defaults. After creating a site setup and
z
editing default parameters as desired, save the site using the name [FASTSTRT]. The next time you
issue the Create/Name Site command, your custom parameters will become the systems defaults.
THE CHANNEL/PATH SETUP MENU
4-1
1010GCNFM-3C