Creating A New Site Setup - Siemens SITRANS F Operating Instructions Manual

Section 1
To select [Clamp-on] press
nel 1. Note that the first menu, [Channel Setup], is highlighted.
Creating a New Site Setup (See also paragraph 2.1.3)
The Channel Setup section of this manual provides detailed instructions on how to use all the Channel
Setup menu commands. This section provides an example of how to use the [Create/Rename Site]
command to create a new site setup. Always begin a new installation by issuing the [Create/Name
Site] command. Although you do not need to enter a site name to create a new site setup, you have to
provide one to save the site setup or to identify the source of logged data. In this example, we will use
[SITE1] for the site name.
To access the [Channel Setup] menu press
with the key.
Press . Note that the cursor changes to a block, which appears after a question mark (?). This
indicates that you have accessed the first character position of an eight-character (maximum) alpha-
numeric entry field.
Siemens 2 Channel [1]
Choose Channel 1 Flowmeter Type
Channel 1
Channel 2
Channel Setup
. This selects the Clamp-on installation menu for Measurement Chan-
then move the highlight down to [Create/Name Site]
Siemens 2 Channel [1]
Right Arrow & Enter Creates a new Site
Recall Site Setup
Channel Enable
Create/Name Site
Site Security
Delete Site Setup
Save/Rename Site
Channel Setup
1-19
Channel 1
>Clamp-on
FlowTube
Reflexor
Channel 1
No Sites
No
Off
No Sites
1010PFM-3G