Recording Schedule - Interlogix TruVision TVB-5702 Configuration Manual

3. Enter the quota percentage for snapshots and recordings. Modify the values for
each in Percentage of Snapshot
4. Enter the quota percentage for snapshots and recording to allocate the storage
capacities to the camera.
5. Click Save to save changes.

Recording schedule

You can define a recording schedule for the camera in the "Record Schedule" window.
The recording is saved on the SD card in the camera or on a NAS. The camera's SD
card provides a backup in case of network failure. The SD card is not provided with the
camera.
The recording schedule applies to all alarm types.
Pre-record time
The pre-record time is set to start recording before the scheduled time or event. For
example, if an alarm triggers recording at 10:00, and the pre-record time is set as 5
seconds, the camera starts to record at 9:59:55. The pre-record time can be configured
as No Pre-record, 5 s, 10 s, 15 s, 20 s, 25 s, 30 s, or Not Limited.
Post-record time
The post-record time is set to stop recording after the scheduled time or the event. For
example, if an alarm triggered recording ends at 11:00, and the post-record time is set
as 5 seconds, the camera records until 11:00:05. The post-record time can be
configured as 5 s, 10 s, 30 s, 1 min, 2 min, 5 min, or 10 min.
To set up a recording schedule:
1. From the Configuration panel, click
2. Click the Enable Record Schedule
Note: To disable recording, deselect the option.
3. Click Edit to edit the recording schedule. The following window appears:
TruVision IP Thermal Camera Configuration Manual
and Percentage of
Configuration > Storage
box to enable recording.
Record.
> Record Schedule.
67