Fire Source Detection - Interlogix TruVision TVB-5702 Configuration Manual

To define scene change detection:
1. From the Configuration panel, click
Detection.
2. Select the Enable Scene Change Detection check box to enable the function.
3. Configure the sensitivity ranging from 1 to 100. The higher the sensitivity, the easier
the change of scene can trigger an alarm.
3. Click Edit to set the arming schedule for the alarm input. See "Set the arming
schedule" on page 36 for more information.
4. Specify the linkage for method when an event occurs. Select one or more response
methods for the system when a scene change detection alarm is triggered.
Notify Surveillance Center
Send Email
Upload to FTP
Trigger Channel
Trigger Alarm Output
5. Click Save to save changes.

Fire source detection

You can configure the camera to trigger an alarm when the camera detects a fire
source.
IMPORTANT NOTICE: This fire detection feature is not a substitute for a
certified fire detection system.
TruVision IP Thermal Camera Configuration Manual
Configuration
Sends an exception or alarm signal to remote management software
when an event occurs.
Sends an email to a specified address when there is a scene change
detection alarm.
Note: You must configure email settings before enabling this option.
See "To set up the email parameters" on page 17 for further
information. If you want to send the event snapshot together with the
email, select the Attached Snapshot
Captures the image when an alarm is triggered and uploads the
snapshot to an FTP server.
Note: To upload the snapshot to an FTP, you must first configure the
FTP settings. See "To define the FTP parameters" on page 18 for
further information. Enable the
To upload the snapshot to FTP when motion detection or an alarm
input is triggered, you must also select the
Snapshot check box in the snapshot parameters. See "Snapshot
parameters" on page 54 for further information.
Triggers the recording to start in the camera.
Triggers external alarm outputs when an event occurs. Select
All or individual alarm outputs.
Note: This option is only supported by cameras that support alarm
output.
> Smart Event > Scene Change
option
Upload Type option.
Enable Event-triggered
Select
43