Upload to FTP
Trigger Channel
Trigger Alarm Output
Click
OK
to save the changes.
6. If required, create another new point, line, or frame and set up the rules associated
with it. Repeat steps 2 to 5.
7. Click
Save
to save the settings.
TruVision IP Thermal Camera Configuration Manual
Capture the image when an alarm is triggered and upload the
snapshot to an FTP server.
Note: To upload the snapshot to an FTP, you must first configure the
FTP settings. See "To define the FTP parameters" on page 18 for
further information. Enable the
To upload the snapshot to an FTP when motion detection or an alarm
input is triggered, you must also select the
Snapshot
check box in the snapshot parameters. See "Snapshot
parameters" on page 45 for further information.
Triggers the recording to start in the camera.
Trigger external alarm outputs when an event occurs. Select
All
or each individual alarm output.
Note: This option is only supported by cameras that support an alarm
output.
Upload Type
option.
Enable Event-triggered
Select
53