Network Configuration - Interlogix TruVision TVB-5702 Configuration Manual

Network configuration

You need to define the network settings to be able to access the camera through a
network. Use the "Network" menu to define the network settings. See Figure 4 below for
further information.
Caution: We strongly recommend that you use a strong password for all functions and
network devices in order to protect your privacy and to protect your system against
security risks. A valid password range must be at least eight characters. You can use a
combination of numbers, lower and upper case letters, and special characters. The
installer and/or end user are responsible for password management.
Figure 4: Network window (TCP/IP tab shown)
Menu tabs
1. TCP/IP
14
Description
NIC Type: Enter the NIC type. Default is Auto. Other options include: 10M Half-
dup, 10M Full-dup, 100M Half-dup and 100M Full-dup.
DHCP: Enable in order to automatically obtain an IP address and other network
settings from that server.
IPv4 Address: Enter the IPv4 address of the camera.
IPv4 Subnet Mask: Enter the IPv4 subnet mask.
IPv4 Default Gateway: Enter the IPv4 gateway IP address.
IPv6 Mode: Enter the IPv6 mode: Manual, DHCP, or Route Advertisement.
IPv6 Address: Enter the IPv6 address of the camera.
IPv6 Subnet Prefix Length: Enter the IPv6 prefix length.
IPv6 Default Gateway: Enter the IPv6 gateway IP address.
Mac Address: Enter the MAC address of the devices.
MTU: Enter the valid value range of MTU. Default is 1500.
TruVision IP Thermal Camera Configuration Manual