Alarm Inputs And Outputs - Interlogix TruVision TVB-5702 Configuration Manual

Send Email
Trigger Alarm Output
6. Click Save to save changes.

Alarm inputs and outputs

To define the external alarm input:
1. From the Configuration panel, click
2. Choose the Alarm Input No.
(Normally Open) or NC (Normally Closed). Enter a name for the alarm input, if
desired.
3. Click Edit to set the arming schedule for the alarm input. The arming schedule
configuration is the same as that for motion detection. See "Set the arming
schedule" on page 36 for more information.
4. Specify the linkage method. Select one or more response methods for the system
when an alarm input is triggered.
Notify Surveillance Center Send an exception or alarm signal to remote management software
Send Email
Trigger Alarm Output
5. Click Save to save changes.
To define alarm output:
1. From the Configuration panel, click
2. Select one alarm output channel from the
also set a name for the alarm output.
3. The delay time can be set to 5 s, 10 s, 30 s, 1 min, 2 min, 5 min, or 10 min. The
delay time refers to the time duration that the alarm output remains in effect after the
alarm occurs.
TruVision IP Thermal Camera Configuration Manual
Sends an email to a specified address when there is an alarm
triggered.
Note: You must configure email settings before enabling this option.
See "To set up the email parameters" on page 18 for further
information. If you want to send the event snapshot together with the
email, select the Attached Snapshot option.
Trigger external alarm outputs when an event occurs. Select "Select
All" or individual alarm outputs.
Note: This option is only supported by cameras that support alarm
output.
Configuration
and the Alarm
when an event occurs.
Sends an email to a specified address when there is an alarm input
or output alarm.
Note: You must configure email settings before enabling this option.
See "To set up the email parameters" on page 18 for further
information. If you want to send the event snapshot together with the
email, select the Attached Snapshot option.
Trigger external alarm outputs when an event occurs. Select "Select
All" or individual alarm outputs.
Note: This option is only supported by cameras that support alarm
output.
Configuration
Alarm Output
> Basic Event
Type. The alarm type can be NO
> Basic Event
drop-down list. You can
> Alarm Input.
> Alarm Output.
39