Table of Contents
Advertisement
Parameter
3. Single Alarm
4. Leaves Interference
Suppression
5. Output Type
6. Restore Default
7. Restart VCA
8. Set a global size filter. This step is optional.
An individual rule lets you filter for an object whose size is smaller than the minimum
size or larger than the maximum size. However, the global size filter applies to all
rules. You do not need to set individual size filters for each rule.
a) From the Configuration panel, click
Configuration
b) Select the
Global Size Filter
Note: You can delete a defined global size filter by deselecting this check box.
c) Select the type of rule filter. Under "Filter by", select
Actual Size: Enter the length and width in meters of both the maximum and
minimum sizes. Only a target whose size is between the minimum and maximum
values will trigger an alarm.
60
Description
If this is selected, the target in the configured area will trigger the
alarm only once. If it is not checked, the same target will cause a
continuous alarm in the same configured area.
Select this check box to stop the interference caused by leaves in
the configured area.
When the camera detects an object that triggers the rule, a
rectangular frame will surround the object. Select the position of
the frame on the object. Select Target Center, Bottom Center, or
Top Center. For example, the target will be in the center of the
frame if "Target Center" is selected.
Click to restore the configured parameters to default.
Restart the algorithms library of the behavior analysis.
>
Global Size
Filter.
check box to enable the option.
VCA Configuration
Actual Size
TruVision IP Thermal Camera Configuration Manual
>
Advanced
or Pixel.
Advertisement
Table of Contents
