Video tampering alarms
You can configure the camera to trigger an alarm when the lens is covered and to take
an alarm response action.
Figure 9: Tamper-proof alarm window
To set up video tampering alarms:
1. From the Configuration panel, click
Tampering.
2. Select the
Enable Video Tampering
3. Move the
Sensitivity
the whole screen.
4. Click
Edit
to edit the arming schedule. The arming schedule configuration is the
same as that for motion detection. See "Set the arming schedule" on page 36 for
more information.
5. Specify the linkage method when an event occurs. Select one or more response
methods for the system when a tamper-proof alarm is triggered.
Notify Surveillance Center Send an exception or alarm signal to remote management software
38
Configuration
check box.
slider to set the detection sensitivity. The sensitivity applies to
when an event occurs.
>
Basic Event
>
Video
TruVision IP Thermal Camera Configuration Manual