Note: This function is only available when
under the menu
Configuration
type" on page 54 for more information.
To define the fire source detection:
1. From the Configuration panel, click
Detection.
2. Select the
Enable Fire Source Detection
fire source is detected, a red frame appears around the source in the live view
image.
Note: When
Enable Fire Source Detection
under the Local Configuration window that allows you to enable how the fire
information is displayed on the camera. See the instructions on page 18 for further
information.
3. Slide the sensitivity cursor to adjust the sensitivity level of the fire source detection
from 1 to 100. The larger the number, the higher the detection sensitivity level.
Default is 50.
4. Set the arming schedule.
a) Click
Edit
to edit the arming schedule. The "Edit Schedule Time" window
appears.
44
Fire Source Detection
>
System
>
VCA Resource
Configuration
check box to enable the function. When a
is enabled, an extra function appears
has been enabled
Type. See "VCA resource
>
Smart Event
>
Fire Source
TruVision IP Thermal Camera Configuration Manual