Interlogix TruVision TVB-5702 Configuration Manual page 37

Notify Surveillance Center Send an exception or alarm signal to remote management software
Send Email
Upload to FTP
Trigger Channel
Trigger Alarm Output
5. Click Save to save changes.
To set up motion detection in expert mode:
1. From the Configuration panel, click
Detection.
2. Set the motion detection area.
a) Select the Enable Motion Detection
Motion if you want to see real-time motion events.
Note: Select
not want the detected object displayed in green frames.
b) Select Expert
TruVision IP Thermal Camera Configuration Manual
when an event occurs.
Sends an email to a specified address when there is a motion
detection alarm.
Note: You must configure email settings before enabling this option.
See "To set up the email parameters" on page 18 for further
information. If you want to send the event snapshot together with the
email, select the
Captures the image when an alarm is triggered and uploads the
snapshot to an FTP server.
Note: To upload the snapshot to an FTP, you must first configure the
FTP settings. See "To define the FTP parameters" on page 18 for
further information. Enable the
To upload the snapshot to FTP when motion detection or an alarm
input is triggered, you must also select the
Snapshot check box
parameters" on page 54 for further information.
Triggers the recording to start in the camera.
Trigger external alarm outputs when an event occurs. Select "Select
All" or individual alarm outputs.
Note: This option is only supported by cameras that support alarm
output.
Configuration
Disable under Rules in the "Local Configuration" menu if you do
mode from the drop-down menu.
Attached Snapshot option.
Upload Type
in the snapshot parameters. See "Snapshot
> Basic Event
box. Select Enable Dynamic Analysis for
option.
Enable Event-triggered
> Motion
35