6. Specify the linkage method. Select one or more response methods for the system
when an audio exception alarm is triggered.
Notify Surveillance Center Send an exception or alarm signal to remote management
Send Email
Trigger Channel
Trigger Alarm Output
7. Click
Save
to save changes.
Scene change detection
You can configure the camera to trigger an alarm when the camera detects a change in
the scene caused by an intentional rotation of the camera.
Figure 11: Scene change detection window
42
software when an event occurs.
Sends an email to a specified address when there is a motion
detection alarm.
Note: You must configure email settings before enabling this
option. See "To set up the email parameters" on page 18 for
further information. If you want to send the event snapshot
together with the email, select the Attached Snapshot option.
Triggers the recording to start in the camera.
Trigger external alarm outputs when an event occurs. Select
"Select All" or individual alarm outputs.
Note: This option is only supported by cameras that support
alarm output.
TruVision IP Thermal Camera Configuration Manual