Interlogix TruVision TVB-5702 Configuration Manual page 19

To define the DDNS parameters:
If the camera is set up to use PPPoE as its default network connection, you can use
Dynamic DNS (DDNS) for network access. You need to register on the DDNS server
before you can configure the settings.
1. From the Configuration panel, click
2. Select Enable DDNS
3. Select the DDNS
• DynDNS: Enter the DDNS server address, members.ddns.org (which is used to
notify DDNS about changes to your IP address), the host name for your camera,
the port number (443 (HTTPS), and your user name and password used to log
into your DDNS account. The domain name displayed under "Host Name" is that
which you created on the DynDNS web site.
• ezDDNS: Enter the desired host name under "Host Name". The default host
name is utc-serial number. The new host name is registered when you click
Save.
Note: The default server address is www.tvr-ddns.net, which cannot be changed.
4. Click Save to save changes.
To define the PPPoE parameters:
1. From the Configuration panel, click
2. Select Enable PPPoE
3. Enter the user name, password, and confirm the password for PPPoE access.
4. Click Save to save changes.
To define the SNMP parameters:
1. From the Configuration panel, click
2. Select the corresponding version of SNMP: v1, v2c or v3.
3. Configure the SNMP settings. The configuration of the SNMP software should be
the same as the settings you configure here.
4. Click Save to save changes.
Note: Before setting the SNMP, please download the SNMP software to receive the
camera information via the SNMP port. By setting the trap address, the camera can
send the alarm event and exception messages to the surveillance center. The SNMP
version you select should be the same as that of the SNMP software. The security level
of the software depends on its version. SNMP v1 has no security. SNMP v2 requires a
password for access. SNMP v3 provides encryption. If you use SNMP v3, you must
enable HTTPS.
TruVision IP Thermal Camera Configuration Manual
Configuration
to enable this feature.
Type. There are two options available: DynDNS and ezDDNS.
Configuration
to enable this feature.
Configuration
> Network > DDNS.
> Network > PPPoE.
> Network > SNMP.
17