Vertical Plc Soft Keys; Display/Delete Plc Soft-Key Row - HEIDENHAIN iTNC 530 Technical Manual

7.2 PLC Soft Keys

7.2.1 Vertical PLC Soft Keys

Display/delete PLC
soft-key row
February 2002
In the following operating modes you can display your own soft keys through
the PLC:
n
MANUAL
n
ELECTRONIC HANDWHEEL
n
POSITIONING WITH MANUAL DATA INPUT
n
PROGRAM RUN, FULL SEQUENCE
n
PROGRAM RUN, SINGLE BLOCK
You can create the soft keys with PLCdesign.
When a PLC soft key is pressed the NC enters the soft-key number in W302.
On the rising edge of the keystroke it enters the soft-key number; on the
falling edge it enters –1. The PLC can enter –1 itself after recognizing the soft-
key number.
With Module 9200 you can display entire soft-key rows. With Module 9201
you can show individual soft keys. With Module 9202 you can switch to the
display with PLC soft keys and PLC windows. This module works like the
screen management key.
7 In the system file PLC:\PLCSOFTK.SYS, enter the names and path of the
required soft-key files. With the sequence of your entries you specify the
soft-key number: Line 0 = soft-key number 0, etc. One soft-key level can
consist of up to four soft-key rows, i.e. 32 soft keys per level.
7
When calling the module, indicate the row to be displayed first.
7 With the transfer parameter, specify how the soft keys should be displayed:
• After the screen management key is pressed, i.e. after the PLC window
is selected
• In the current operating mode
In this case the NC soft keys are overwritten.
7
Specify whether the NC soft keys should be overwritten or whether the PLC
soft keys should be appended to the NC soft keys. If you append the PLC
soft keys, a separate list is opened. Only one PLC soft-key row can be
appended.
W302 Number of the horizontal PLC soft
key that was pressed
PLC Soft Keys
Set Reset
NC NC
7 – 13