HEIDENHAIN iTNC 530 Technical Manual page 577

Group Group
name number
ID....
Datum from touch probe cycle
360
Read values from active datum table
500
501
505
Write values from active pallet table
510
Touch probe cycles
990
8 – 32
System data System data
number index
NR.... IDX....
1 1 to 9
2 1 to 9
3 –
Line Column
Line Column
1 –
1 –
2 –
3 –
4 –
5 1 to 9
6 1 to 9
1 –
2 10
16
System data item
Last datum of a manual touch probe
cycle or last touch point from cycle 0
for the axes 1 to 9 without probe
length compensation, but with probe
radius compensation (workpiece
coordinate system)
Last datum of a manual touch probe
cycle or last touch point from cycle 0
for the axes 1 to 9 without probe
length or radius compensation
(machine coordinate system)
Measurement result of touch probe
cycles 0 and 1 without probe radius
and length compensation
Read values
Read REF values
0 = no datum table selected
1 = datum table selected
Active lines
Pallet number from column Name
Active line of the pallet table
Last line of the NC program of the
current pallet
Tool-Oriented Machining
0 = Safety height not programmed
1 = Safety height programmed
Programmed safety height in a pallet
table for tool-oriented machining
Approach behavior
0 = Standard behavior
1 = Effective radius, safety clearance
zero
0.0 = Execution not in block scan
1.0 = Execution in block scan
–1.0 = Invalid index
0.0 = Execution not in Automatic
operating mode
1.0 = Execution in Automatic
operating mode
–1.0 = Invalid index
HEIDENHAIN Technical Manual iTNC 530