HEIDENHAIN iTNC 530 Technical Manual page 346

Hide thumbs Also See for iTNC 530:

Table of Contents

Mode of operation

1: MANUAL OPERATION

2: ELECTRONIC HANDWHEEL

3: POSITIONING WITH MANUAL

4: PROGRAM RUN, SINGLE BLOCK

5: PROGRAM RUN, FULL SEQUENCE

7: REFERENCE MARK TRAVERSE

Reference marks not yet traversed

Bits 0 to 8 correspond to axes 1 to 9

Reference end position

Bits 0 to 8 correspond to axes 1 to 9

HEIDENHAIN Technical Manual iTNC 530