Module 9034 Load A Machine Parameter Subfile - HEIDENHAIN iTNC 530 Technical Manual

February 2002

Module 9034 Load a machine parameter subfile

With this module you load the contents of the given machine parameter into
the main memory. All MPs not listed in this file remain unchanged.
The MP file to be selected is checked. A faulty file is not loaded. If the MP file
contains parameters that require a system reset, the file is not loaded.
The file name is transferred in a string that must contain the complete path,
name and file extension. Further characters, even space characters, are not
permitted.
If the PLC program is created externally, ensure that lower-case letters are not
used for the file name!
Once the NC program has started, the module operates only during the output
of an M/S/T/Q strobe.
Call only in a submit job.
Call:
PS B/W/D/K <>String number>
0 to 3
CM 9034
PL B/W/D <>Error code>
0: No error
1: String does not contain a valid file name,
or the name (including the path) is too long.
2: File not found
3: File is faulty / contains reset parameters
4: Incorrect string number was transferred (0 to 3)
5: Call was not in a submit job
6: Call during running program without strobe
Input and Output of Machine Parameters 4 – 11