HEIDENHAIN iTNC 530 Technical Manual page 361

Hide thumbs Also See for iTNC 530:

Table of Contents

February 2002

Acceleration

0.001 to 100.0 [m/s

Max. permissible axis-specific jerk for Manual mode

0.1 to 1000.0 [m/s

Max. permissible axis-specific jerk for Pass Over Reference

0.1 to 1000.0 [m/s

Maximum permissible jerk on the tool path

0.1 to 1000.0 [m/s

With machining feed rate

Beginning with feed rate from MP1092

Feed rate threshold from which MP1090.1 becomes

10 to 300 000 [mm/min]

0: HSC filter inactive

0.1 to 166.0: Cutoff frequency for HSC filter

Nominal position value filter

0: Single filter

1: Double filter

In the Program Run, Full Sequence; Program Run, Single Block;

and Positioning With Manual Data Input operating modes

In the Manual, Handwheel, Jog Increment and Pass Over

Reference Point operating modes

Tolerance for contour transitions

0: No nominal position value filter

0.001 to 3.000 [mm]: Permissible tolerance at contour

Max. permissible axis-specific jerk (single/HSC filter)

0.1 to 1000.0 [m/s

Max. permissible axis-specific jerk (double/HSC filter)

0.1 to 1000.0 [m/s

Minimum filter order

Minimum filter configuration for single filter (MP1095 = 0)

Minimum filter configuration for double filter (MP1095 = 1)

Transient response during acceleration and deceleration

1 to 255 [ms]

0: Function inactive

The Control Loop