HEIDENHAIN iTNC 530 Technical Manual page 208

MP Function and input
MP7289 Position display step for the spindle
Input:
MP7290.0-8 Position display step for axes 1 to 9
MP7291 Display of axes on the screen
Format:
Input:
to 9
MP7291.0 Display in traverse range 1
MP7291.1 Display in traverse range 2
MP7291.2 Display in traverse range 3
MP7295 Disabling "datum setting"
Format:
Input:
MP7296 "Datum setting" through axis keys
Input:
4 – 48
0: 0.1°
1: 0,05°
2: 0,01°
3: 0,005°
4: 0,001°
5: 0,0005°
6: 0,0001°
0: 0.1 mm or 0.1°
1: 0.05 mm or 0.05°
2: 0.01 mm or 0.01°
3: 0.005 mm or 0.005°
4: 0.001 mm or 0.001°
5: 0.0005 mm or 0.0005°
6: 0.0001 mm or 0.0001°
SXYZABCUVWxyzabcuvw-
Characters 1 to 9 from the right represent lines 1
Character 10 is spindle S which is always output
in line 9.
%xxxxxxxxx
Bits 0 to 8 correspond to axes 1 to 9
0: Not disabled
1: Disabled
0: Datum can be set by axis keys and soft key
1: Datum can be set only by soft key
Software
version and
behavior
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
PLC
RUN
CN123
PLC
RUN
CN123
HEIDENHAIN Technical Manual iTNC 530
Page
6 – 3