HEIDENHAIN iTNC 530 Technical Manual page 216

MP Function and input
MP7450 Offsetting the tool change position from MP951.x in block
scan
Format:
Input:
MP7451.0-8 Feed rate for returning to the contour for axes 1 to 9
Input:
MP7470 Maximum contouring tool feed rate at 100% override
Input:
MP7471 Maximum velocity of the principle axes during
compensating movements through M128
Input:
MP7475 Reference for datum table
Input:
MP7480 Output of the tool or pocket number
MP7480.0 With TOOL CALL block
Input:
MP7480.1 With TOOL DEF block
Input:
4 – 56
%xxxxxxxxxxxxxx
Bits 0 to 3 correspond to axes 1 to 14:
0: Do not offset
1: Offset
10 to 300 000 [mm/min]
0 to 300 000 [mm/min]
0: No limitation
0 to 300 000 [mm/min]
0: Reference is workpiece datum
1: Reference is machine datum (MP960.x)
0: No output
1: Tool number output only when tool number
changes
2: Tool number output for every TOOL CALL
block
3: Output of the pocket number and tool number
only when tool number changes
4: Output of the pocket number and tool number
for every TOOL CALL block
5: Output of the pocket number and tool number
only when tool number changes. Pocket table is
not changed.
6: Output of the pocket number and tool number
for every TOOL CALL block. Pocket table is not
changed.
0: No output
1: Tool number output only when tool number
changes
2: Tool number output for every TOOL DEF block
3: Output of the pocket number and tool number
only when tool number changes
4: Output of the pocket number and tool number
for every TOOL DEF block
Software
version and
behavior
PLC
RUN
PLC
RUN
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
HEIDENHAIN Technical Manual iTNC 530
Page
6 – 82