HEIDENHAIN iTNC 530 Technical Manual page 207

MP Function and input
MP7267 Elements of the pocket table
Input:
MP7267.0 Tool number (T)
MP7267.1 Special tool (ST)
MP7267.2 Fixed pocket (F)
MP7267.3 Locked pocket (L)
MP7267.4 PLC status (PLC)
MP7267.5 Tool name (TNAME)
MP7267.6 Comment on the tool (DOC)
MP7267.7 Tool type for pocket table (PTYP)
MP7267.8 Value 1 (P1)
MP7267.9 Value 2 (P2)
MP7267.10 Value 3 (P3)
MP7267.11 Value 4 (P4)
MP7267.12 Value 5 (P5)
MP7267.13 Reserve pocket (RSV)
MP7267.14 Pocket above locked (LOCKED_ABOVE)
MP7267.15 Pocket below locked (LOCKED_BELOW)
MP7267.16 Pocket at left locked (LOCKED_LEFT)
MP7267.17 Pocket at right locked (LOCKED_RIGHT)
MP7270 Feed rate display in the operating modes MANUAL
OPERATION and ELECTRICAL HANDWHEEL
Input:
MP7280 Decimal character
Input:
MP7281 Depiction of the NC program
Input:
MP7285 Tool length offset in the tool-axis position display
Input:
February 2002
0: No display
1 to 99: Position in the pocket table
0: Display of feed rate by pressing
an axis direction key (axis-specific feed rate from
MP1020)
1: Display of axis feed rate also before an axis
direction key is pressed (smallest value from
MP1020 for all axes)
0: Decimal comma
1: Decimal period
0: All blocks completely
1: Current block completely, others line by line
2: All blocks line by line; complete block when
editing
0: Tool length is not offset
1: Tool length is offset
List of Machine Parameters
Software Page
version and
behavior
CN123
340 420-02
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
4 – 47