Module 9171 Oriented Spindle Stop - HEIDENHAIN iTNC 530 Technical Manual

6 – 196
M4000 Spindle in position
M4012 Opening the spindle control loop
M4015 Renewed evaluation of the spindle
reference mark
M4017 Spindle moving in feedback control
M4018 Reference mark for spindle not yet
traversed
With Module 9171 you can specify the speed, nominal position and direction
of rotation for spindle orientation.
M4130 is set as long as the positioning movement lasts.

Module 9171 Oriented spindle stop

The module functions only in the cyclic PLC program. If you call the module
while the spindle is rotating, the transferred direction will be ignored. The
spindle will be oriented in the direction of spindle rotation.
If the values 2 to 4 are transferred as direction of rotation, the spindle will be
oriented to the angle last defined in CYCL DEF 13. The transferred angle is
added to the value from CYCL DEF 13.
Call:
PS B/W/D/K <>Angle [1/10 000 °]>
or additional preset if there is a value from CYCL DEF 13
PS B/W/D/K <>speed [1/1000 rpm]>
0: MP3520.1 is assumed
PS B/W/D/K <>Direction of rotation>
–1: Negative direction (M04)
0: Direction of the shortest path
1: Positive direction (M03)
2: Same as –1 but angle from CYCL DEF 13
3: Same as 0 but angle from CYCL DEF 13
4: Same as +1 but angle from CYCL DEF 13
CM 9171
Error detection:
Marker Value Meaning
M4203 0 Spindle is brought to an oriented stop
1 Error code in W1022
W1022 1 Incorrect value for direction of rotation or rotational
angle
2 Incorrect speed
19 No feedback-controlled spindle
24 The module was called in a spawn job or submit job
27 A spindle orientation is already running
Set
NC
PLC
PLC
NC
NC
HEIDENHAIN Technical Manual iTNC 530
Reset
NC
PLC
NC
NC
NC