HEIDENHAIN iTNC 530 Technical Manual page 571

Group Group
name number
ID....
Coordinate transformation
PLC data
2000
8 – 26
System data System data
number index
NR.... IDX....
4 1
2
5 5
8 –
10 Marker no.
System data item
Transformation of the manual mode
coordinate system into the active
coordinate system (e.g. rotated,
shifted ).
Transformation of the active
coordinate system (e.g. rotated,
shifted ) into the manual mode
coordinate system.
Ask if due to a tilt motion, an axis is
shown in an untilted coordinate
system on top of another axis. The
number of the first of two sequential
Q parameters must be given. It
contains the axis to be asked
(0 = X, 1 = Y, 2 = Z).
The second Q parameter should
return the corresponding image
(0 = X, 1 = Y, 2 = Z, –1 = Axis has no
image).
Spindle orientation including the
angle
PLC markers
HEIDENHAIN Technical Manual iTNC 530