Spindle - HEIDENHAIN iTNC 530 Technical Manual

4.3.6 Spindle

MP Function and input
MP3010 Output of speed, gear range
Input:
MP3011 Function of analog output S, if MP3010 < 3
Input:
MP3012 Feed rate from output of an analog voltage of 10 V,
MP3011 = 1
Input:
MP3013.x Characteristic curve kink points (velocity) for output of the
analog voltage with M202
Input:
MP3014.x Characteristic curve kink points (voltage) for output of the
analog voltage with M202
Input:
MP3020 Speed range for S code output
Format:
Input:
4 – 28
0: No output of spindle speed
1: Speed code if the speed changes
2: Speed code at every TOOL CALL
3: Nominal speed value always, G code if the
gear range shifts
4: Nominal speed value always, G code at every
TOOL CALL
5: Nominal speed value always, no G code
6: Same as 3, but with controlled spindle for
orientation
7: Same as 4, but with controlled spindle for
orientation
8: Same as 5, but with controlled spindle for
orientation
0: No special function
1: Voltage is proportional to the current
contouring feed rate, depending on MP3012
2: Voltage is defined as through Module 9130
3: Voltage is defined through M functions (M200
to M204)
0 to 300 000 [mm/min]
10 to 300 000 [mm/min]
0.000 to 9.999 [V]
xxyyz
xx: S code for minimum speed
yy: S code for maximum speed
z: speed increment
0 to 99 999
Software
version and
behavior
PLC
RUN
PLC
RUN
PLC
RUN
PLC
RUN
HEIDENHAIN Technical Manual iTNC 530
Page
6 – 179
6 – 191