Communication Channels For Profinet; Drive Control With Profinet - Siemens sinamics dcp Operating Instructions Manual

8.6.2.4

Communication channels for PROFINET

Control Unit with CBE20
A Communication Board can be optionally inserted in the Control Unit CUD: The CBE20
Communication Board is a PROFINET switch with four PROFINET ports.
Overview of important parameters
(see SINAMICS DCP List Manual)
• p8829
• p8940[0...239]
• p8941[0...3]
• p8942[0...3]
• p8943[0...3]
• p8944
• p8945
• r8950[0...239]
• r8951[0...3]
• r8952[0...3]
• r8953[0...3]
• r8954
• r8955[0...5]
• r8959
8.6.3

Drive control with PROFINET

PROFINET interfaces
The CBE20 option module can be inserted in the option slot of a CUD. The CBE20 is a
PROFINET switch with four ports.
Note
Ring topology
When connecting the ports, it must be ensured that for standard applications a ring topology
is not created. Additional information on ring topologies can be found in Chapter Media
redundancy (Page 207).
SINAMICS DCP
Operating Instructions, 05/2016, A5E34382853K
CBE20 remote controller number
CBE20 name of station
CBE20 IP address of station
CBE20 default gateway of station
CBE20 subnet mask of station
CBE20 DHCP mode
CBE20 interface configuration
CBE20 name of active station
CBE20 IP address of active station
CBE20 default gateway of active station
CBE20 subnet mask of active station
CBE20 DHCP mode active
CBE20 MAC address of station
CBE20 DAP ID
8.6 Communication via PROFINET IO
Operation
205