HEIDENHAIN iTNC 530 Service Manual page 88



10 – 88
 Press this soft key.
ON is highlighted; the I/O-FORCE LIST is active.
If you now exit the I/O-FORCE LIST with END, the following display is shown:
DANGER
The text I/O-Force is active is now shown in the PLC mode. If a machine operating mode
is displayed on the monitor (e.g., Program Run, Full Sequence), this informational text is not
visible!
Note
If you call the TABLE with the INPUTS and OUTPUTS, the "forced" inputs and outputs are
displayed in a different color (e.g., blue).
DANGER
Do not forget to deactivate the I/O-Force List after the tests have been performed!
As a precaution also delete all lines in the I/O-FORCE LIST!
HEIDENHAIN Service Manual iTNC 530