HEIDENHAIN iTNC 530 Service Manual page 252

Hide thumbs Also See for iTNC 530:

Table of Contents

Check the transmission mode (binary-ASCII conversion). It should be set as follows:

Enter the same subnet mask as that of your laptop.

Press the soft key ACTIVATE LINE (if available, depending on the NC software version).

Press END twice.

The control now reboots.

Start the HEIDENHAIN data transfer program TNCremoNT.

Click this icon to open the configuration window (can also be opened via

Extras/Configuration ...).

Now click on Connection and select TCP/IP (Ethernet connection).

Subsequently, click on Settings and enter the IP address of the control.

Confirm with Apply and OK.

Click this icon. --> The connection is established.

HEIDENHAIN Service Manual iTNC 530

Troubleshooting