HEIDENHAIN iTNC 530 Service Manual page 342

Hide thumbs Also See for iTNC 530:

Table of Contents

Investigation with

With the integrated oscilloscope the Volt. analog voltage can observed:

the integrated

oscilloscope

See "Integrated Oscilloscope" on page 8 – 49.

Error: No axis

It is a prerequisite that the release conditions (e.g., door contacts, permissive buttons, etc.)

for the axis movements are given.

For the axes to be traversed ...

If necessary, ask the machine operator!

No terminal symbol before the axis concerned must be shown.

The feed rate display (F ...) must not be highlighted.

The "STIB" star (control in operation) must be shown.

HEIDENHAIN Service Manual iTNC 530

Troubleshooting