HEIDENHAIN iTNC 530 Service Manual page 534

MP
MP7682
30 – 534
Function and input
Machine parameter with multiple function
Format:%xxxxxxxx
Input:Bit 0 – Incremental block after
TOOL CALL
0: With length compensation
1: Without length compensation
Bit 1 – Reference value for calculating the preset
during datum setting
0: Actual value is calculated
1: Nominal value is calculated
Bit 2 – Traverse path of rotary axes with modulo
display
0: Positioning without passing over zero
1: Positioning on the shortest path
Bit 3 – Reserved, enter 0
Bit 4 – Tolerance of rotary axes with M128 or
TCPM
0: With consideration of head dimensions
1: Without consideration of head dimensions
Bit 5 – Feed rate with M128 or TCPM
0: Feed rate refers to tool tip
1: Feed rate from interpolation of all axes invol-
ved
Bit 6 – Behavior with TOOL DEF strobe
0: Depending on the NC program, the TOOL DEF
strobe must be acknowledged by the PLC
(TOOL DEF within a contiguous contour)
1: TOOL DEF strobe must always be acknowled-
ged by the PLC
Bit 7 – Block elements TOOL CALL and S in ISO
blocks
0: Machine as programmed
1: Machine at beginning of block (block display
does not change)
Behavior/
SW vers.
PLC
RUN
HEIDENHAIN Service Manual iTNC 530