HEIDENHAIN iTNC 530 Service Manual page 523

MP
MP7431
MP7440
MP7441
MP7442
MP7450
May 2006
Function and input
Arc end-point tolerance
Input:0.0001 to 0.016 [mm]
Output of M functions
Format:%xxxxxxx
Input:Bit 0 – Program stop with M06
0: Program stop with M06
1: No program stop with M06
Bit 1 – Modal cycle call M89
0: Normal code transfer of M89 at beginning of
block
1: Modal cycle call M89 at end of block
Bit 2 – Program stop with M functions:
0: Program stop until acknowledgment of the M
function
1: No program stop: No waiting for acknowledg-
ment.
Bit 3 – Switching of k
M106:
0: Function is not in effect
1: Function is effective
Bit 4 – Reduced feed rate in the tool axis with
M103:
0: Function is not in effect
1: Function is effective
Bit 5 – Reserved
Bit 6 – Automatic activation of M134
0: M134 must be activated in the NC program
1: M134 is automatically activated when an NC
program is selected.
Error message during cycle call
Format:%xxx
Input:Bit 0 –
0: Error message Spindle ? is not sup-
pressed
1: Error message Spindle ? is suppres-
sed
Bit 1: Reserved, enter 0
Bit 2 –
0: Error message Enter depth as nega-
tive is suppressed
1: Error message Enter depth as nega-
tive is not suppressed
Number of the M function for spindle orientation in the
cycles
Input:1 to 999: Number of the M function
0: No oriented spindle stop
–1: Oriented spindle stop by the NC
Offsetting the tool change position from MP951.x in block
scan
Format:%xxxxxxxxxxxxxx
Input:Bits 0 to 3 represent axes 1 to 14:
0: Do not offset
1: Offset
Behavior/
SW vers.
PLC
RUN
CN123
PLC
RUN
CN123
factors with M105/
v
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
30 – 523