Help Key - HEIDENHAIN iTNC 530 Service Manual

Hide thumbs Also See for iTNC 530:

Table of Contents

HELP Key

If the service technician presses the HELP key a window is shown that describes the cause

of error and possibilities of corrective action in addition to the displayed error message.

This support can also be realized for PLC error messages by the machine manufacturer!

Display help texts for error messages

(if this key is pressed again, the window will be closed)

HELP texts cannot be displayed any more for error messages in red windows. The control

is not in operating condition any more. It must be rebooted.

Information on these errors can be found in the list of NC error messages;

See "List of NC Error Messages" on page 22.