3-D Touch Probe - HEIDENHAIN iTNC 530 Service Manual

Hide thumbs Also See for iTNC 530:

Table of Contents

30.4.9 3-D Touch Probe

Function and input

Selection of the touch probe

Input:0: Touch probe with cable transmis-

sion (TS 120, TS 220)

1: Touch probe with infrared transmission (TS

2: Touch probe with infrared transmission (TS

440, TS 640)

Probing feed rate

Input:1 to 3000 [mm/min]

Maximum measuring range

Input:0.001 to 99,999.9999 [mm]

Setup clearance over measuring point

Input:0.001 to 99,999.9999 [mm]

Rapid traverse in probing cycle

Input:10 to 20,000 [mm/min]

M function for probing from opposite directions

Input:–1: Spindle orientation directly by

0: Function inactive

1 to 999: Number of the M function for spindle

orientation through PLC

M function for orienting the touch probe before every

measuring process

Input:–1: Spindle orientation directly by

0: Function inactive

1 to 999: Number of the M function

Orientation angle

Input:0 to 359.9999 [°]

Minimum difference between the current spindle angle and

MP6162 before executing an oriented spindle stop

Input:0 to 3.0000 [°]

Orient the probe before approaching with Cycle 0 or 1, or

with manual probing

Input:0: Probe is not oriented before each

1: Probe is oriented and always deflected in the

same direction

HEIDENHAIN Service Manual iTNC 530