HEIDENHAIN iTNC 530 Service Manual page 516

MP
MP7267.7
MP7267.8
MP7267.9
MP7267.10
MP7267.11
MP7267.12
MP7267.13
MP7267.14
MP7267.15
MP7267.16
MP7267.17
MP7270
MP7280
MP7281
MP7285
MP7289
MP7290.0-8
30 – 516
Function and input
Tool type for pocket table (PTYP)
Value 1 (P1)
Value 2 (P2)
Value 3 (P3)
Value 4 (P4)
Value 5 (P5)
Reserve pocket (RSV)
Pocket above locked (LOCKED_ABOVE)
Pocket below locked (LOCKED_BELOW)
Pocket at left locked (LOCKED_LEFT)
Pocket at right locked (LOCKED_RIGHT)
Feed rate display in the operating modes MANUAL
OPERATION and ELECTRONIC HANDWHEEL
Input:0: Display of axis feed rate through
pressing an axis direction key (axis-specific feed
rate from MP1020)
1: Display of axis feed rate also before an axis
direction key is pressed (smallest value from
MP1020 for all axes)
Decimal character
Input:0: Decimal comma
1: Decimal period
Depiction of the NC program
Input:0: All blocks completely
1: Current block completely, others line by line
2: All blocks line by line; complete block when
editing
Tool length offset in the tool-axis position display
Input:0: Tool length is not offset
1: Tool length is offset
Position display step for the spindle
Input:0: 0.1°
1: 0,05°
2: 0,01°
3: 0,005°
4: 0,001°
5: 0,0005°
6: 0,0001°
Position display step for axes 1 to 9
0: 0.1 mm or 0.1°
1: 0.05 mm or 0.05°
2: 0.01 mm or 0.01°
3: 0.005 mm or 0.005°
4: 0.001 mm or 0.001°
5: 0.0005 mm or 0.0005°
6: 0.0001 mm or 0.0001°
Behavior/
SW vers.
340 420-02
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
PLC
RUN
CN123
HEIDENHAIN Service Manual iTNC 530