HEIDENHAIN iTNC 530 Service Manual page 525

MP
MP7481.x
MP7481.0
MP7481.1
MP7481.2
MP7481.3
MP7482
MP7490
MP7492.x
MP7492.0
MP7492.13
MP7494
May 2006
Function and input
Sequence for new and returned tool when changing tools
Format:%xxxx
0: First, output the pocket of the tool to
be returned
1: First, output the pocket of the new
tool
Input:Bit 0: New tool from magazine 1
Bit 1: New tool from magazine 2
Bit 2: New tool from magazine 3
Bit 2: New tool from magazine 4
Tool from magazine 1 to be returned
Tool from magazine 2 to be returned
Tool from magazine 3 to be returned
Tool from magazine 4 to be returned
Pocket coding of the tool magazine
Format:%xxxx
0: Variable pocket coding
1: Fixed pocket coding
Input:Bit 0: Magazine 1
Bit 1: Magazine 2
Bit 2: Magazine 3
Bit 3: Magazine 4
Functions for traverse ranges
Format:%xxxx
Input:Bit 0 –
0: Display one traverse range with MOD
1: Display three traverse ranges with MOD
Bit 1 –
0: Each traverse range has its own datum (and 3
memories for the positions of the swivel head)
1: One datum for all traverse ranges
Bit 2 – Calibration data: touch probe for work-
piece measurement:
0: One set of calibration data for all traverse ran-
ges
1: Every traverse range has its own set of calibra-
tion data
Bit 3 – Calibration data: touch probe for tool mea-
surement:
0: One set of calibration data for all traverse ran-
ges
1: Every traverse range has its own set of calibra-
tion data
Number of axis in which the same datum is to be set during
Datum Setting (with active preset table)
Input:0 to 9
–1: Do not set a datum
Datum set in the first axis
to
Datum set in the 14th axis
Axes for which an exact stop is to occur after positioning
Format:%xxxxxxxxxxxxxx
Input:Bits 0 to 13 represent axes 1 to 14
0: No exact stop
1: Exact stop
Behavior/
SW vers.
340 420-06
PLC
RUN
340 420-06
PLC
RUN
PLC
RUN
340 422-03,
340 480-03
PLC
RUN
340 422-06,
340 480-06
PLC
RUN
30 – 525