Assignment, Synchronization, Workpiece Transfer; Converting And Mirroring G30 - HEIDENHAIN CNC PILOT 640 User Manual

DIN/ISO programming | Assignment, synchronization, workpiece transfer
4.35 Assignment, synchronization, workpiece
transfer

Converting and mirroring G30

G30 converts G codes, M functions and No. of spindle. G30 mirrors
traverse paths and tool dimensions and shifts the machine datum
about the datum offset of the axis.
Parameters:
H: Table No. of the conversion table (possible only if the machine
tool builder has configured a conversion table)
Q: No. of spindle (default: 0)
For full-surface machining, you describe the complete
Application:
contour, machine the front face, rechuck the workpiece using an
expert program, and then machine the rear face. To enable you to
program rear-face machining in the same way as front-face machining
(Z-axis orientation, arc rotational direction, etc.), the expert program
includes commands for converting and mirroring.
Danger of collision!
Converting and mirroring is retained when switching the operating
mode (e.g. between Machine operating mode and Program run
submode). Danger of collision during subsequent machining
operations!
Always intentionally switch off converting or mirroring
Alternatively, reselect the program
HEIDENHAIN | User's Manual smart.Turn and DIN Programming | 12/2017
NOTICE
4
489